2. Set the laptop's TCP/IP properties as follows:
• IP address: 192.11.13.5
• Subnet mask: 255.255.255.252
• Disable DNS service
• Disable WINS Resolution
3. Connect the laptop computer to the Branch Gateway Services port, using an Ethernet cable.
4. SSH to 192.11.13.6.
5. At the prompt, enter the default username: root and password: rootroot0.
6. At the prompt, configure a new password.
7. At the prompt, enter y to configure basic gateway connectivity.
Note:
If you enter n but then change your mind, you can use the script-config CLI
command to run the installation script, so long as you have not saved any configuration
changes you may have made.
8. You are prompted to configure the following parameters.
For each parameter, you can enter a value, or press Enter to accept the default value shown
in square brackets:
• VLAN number
• IPv4 enabled or disabled
• IPv4 address for the primary management interface
• IPv4 Subnet mask for the primary management interface
• IPv4 address for the default gateway (router)
• IPv6 enabled or disabled
• IPv6 Unicast global address.
• IPv6 prefix length
• IPv6 Link local address
• IPv6 PMI (Global or Link Local)
• IPv6 Default gateway
• Up to eight IP addresses (four IPv4 and four IPv6) to specify the Media Gateway
Controllers
• Hostname for the Branch Gateway
The settings you configured are displayed, and you are prompted for confirmation.
• If you confirm the settings, they are saved and the Branch Gateway reboots.
Branch Gateway configuration
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 61
Comments on this document? infodev@avaya.com
To Next Page
