Avaya G430 - Firmware Specifications

because of unreliable earthing concerns in Finland, Norway, and Sweden, the Branch
Gateway must be installed in a Restricted Access Location (RAL). An RAL is defined as an
access that can be gained only by trained service personnel or customers who have been
instructed about the reasons for the restricted access and any safety precautions that must be
taken. In these cases, access to the Branch Gateway is gained by the use of a tool (such as a
lock and key) or other means of security. If you have any questions about the safety
conditions, contact your project manager. When you have verified that the site is ready for a
safe installation, proceed with the installation.
Firmware Specifications
New Comcode numbers for G430
Old codes will still be active for G430 with imbedded MP20 and MP80 bundle option.
• 700503274 : G430 120 channel DSP daughter board – Single MP120 for upgrades
• 700506957 : G430 MP120 Media Gateway – New bundle no on board MP20 and preinstalled
MP120
• 700506958 : G430 MP120 Media Gateway Non-GSA – New bundle number on board MP20
and preinstalled MP120
• 700508198 : G430 120 CHANNEL DSP daughter board
• 700512173 : G430 V3 40 CHANNEL GSA
• 700512174 : G430 V3 40 CHANNEL NON-GSA
Minimum firmware requirements for G430
Firmware
version
Build v1a v2a
(MP120
Preinstalled)
v3 Comments Recommended CM
Version
- Older versions of CM
will work
BGW 6.1 31.26.
0
Yes No No No BGW
support
MP120
CM 6.0.1
(CM blocks more than 105
channels)
BGW 6.2.1 32.26.
0
Yes No No No BGW
support
MP120
AA 6.2 FP1 CM 6.2 sp 4 —
Dec 2012
(CM blocks more than 105
channels)
BGW 6.3 33.13.
0
Yes No No No BGW
support
MP120
AA 6.2 FP2 CM 6.3 — May
2013
(CM supports all 120
channels)
Table continues…
Before you install
July 2018 Deploying and Upgrading Avaya G430 Branch Gateway 16
Comments on this document? infodev@avaya.com