Avaya G430 - Checking the G430 Hardware Vintage from Branch Gateway CLI

Component File name Example Notes
MM714 Analog Port/Trunk media module mm714v5.fdl
MM714B Analog Port/Trunk media module mm714h10v93.fdl
MM716 Analog Port/Trunk media module mm716v80.fdl
MM717 DCP media module mm717v3.fdl
MM720 BRI media module mm720v1.fdl
MM721 BRI media module mm721v1.fdl
MM722 BRI media module mm722v3.fdl
Example failure message if the wrong image is used
The system displays a failure message if a wrong image is used. Run the following command:
show download software status 10
The system displays the following message:
Module #10
===========
Module : 10
Source file : g430_39_12_0.bin
Destination file : G430-A
Host : 135.9.1.75
Running state : Idle
Failure display : Incompatible software image for this type of device
Last warning : No-warning
Checking the G430 hardware vintage from Branch Gateway CLI
Checking the G430 hardware vintage from the Branch Gateway CLI
About this task
You can check the hardware vintage of the model before downloading the G430 software image.
Before you begin
Login to the application CLI interface.
Procedure
To check the hardware vintage, run the command:
show system and check the rows Model and HW Vintage.
• G430v1 displays the following message:
System Name :
System Location :
System Contact :
Branch Gateway firmware upgrades
July 2018 Deploying and Upgrading Avaya G430 Branch Gateway 85
Comments on this document? infodev@avaya.com