For more information about Spectre and Meltdown fixes included in Avaya Aura
®
Release 7.1.3,
see PSN020346u on the Avaya Support site at: https://downloads.avaya.com/css/P8/documents/
101048606.
IP addresses and controllers
Primary media gateway
controller
IP addresses to configure
S8300 The IP address of the primary S8300
S8400 The IP address of the S8400’s C-LAN or the IP address of an Ethernet port
on the S8400 configured for processor Ethernet connections
S8500 The IP address of the S8500’s C-LAN or the IP address of an Ethernet port
on the S8500 configured for processor Ethernet connections
S8510 The IP address of the S8510’s C-LAN or the IP address of an Ethernet port
on the S8510 configured for processor Ethernet connections
The IP address of the S8700’s C-LAN and the IP address of alternate C-
LAN boards connected to the S8700 (Server A LAN, Server B LAN)
S8710 The IP address of the S8710’s C-LAN and the IP address of alternate C-
LAN boards connected to the S8710
S8720 The IP address of the S8720’s C-LAN and the IP address of alternate C-
LAN boards connected to the S8720
S8730 The IP address of the S8730’s C-LAN and the IP address of alternate C-
LAN boards connected to the S8730
Removing the installation equipment
About this task
Remove all equipment that you used to assist you in the installation process. This may include the
CD-ROM drive, the software upgrade CDs, the laptop computer, and the modem (for installations
without an S8300D or S8300E server module only).
Note:
If you have an S8300D or S8300E server module installed in the Branch Gateway, leave the
modem connected to enable reporting of alarms to remote locations.
Post-installation Verification
July 2018 Deploying and Upgrading Avaya G430 Branch Gateway 61
Comments on this document? infodev@avaya.com
To Next Page
