Chapter 12: Branch Gateway backups and
restores
Branch Gateway backups and restores
You can backup and restore the Branch Gateway to and from a USB mass storage device using a
single CLI command for backup and a single CLI command for restore. This is especially helpful
for efficient restoring or replicating of a Branch Gateway.
If the Branch Gateway is located remotely, you can backup and restore the Branch Gateway files
one by one, using TFTP/FTP/SCP servers.
For information about Branch Gateway backup and restore, see Deploying and Upgrading Avaya
G430 Branch Gateway.
Note:
If FIPS mode is enabled in the gateway in use, previous backups cannot be restored. The
gateway needs to be reconfigured in order to restore from Branch Gateway backup.
July 2018 Deploying and Upgrading Avaya G430 Branch Gateway 99
Comments on this document? infodev@avaya.com
To Next Page
