Avaya G430 - CLI Commands for Upgrading Branch Gateway Firmware Via SCP

- 4620
- 4620SW
- 4621SW
- 4622SW
- 4690
• SIP:
- 4602 SIP
- 4602SW
- 4602SW+
- 4610SW
- 4620SW
- 4621SW
IP telephones not supported by the local TFTP Server feature
• 4630
• 4630SW
Note:
If you have an S8300 installed in the Branch Gateway, you can alternatively upgrade IP
phones using the Communication Manager web pages.
Note:
The IP address of the TFTP server is the PMI.
CLI commands for upgrading Branch Gateway firmware
via SCP
You can use CLI commands to upload an upgrade file to the Branch Gateway. For each of these
commands, include the full path of the file and the IP address of the SCP host as parameters. You
must use the specific path to the file on the SCP server according to the home directory of the
service (SCP) that you are using. When you enter the command, the CLI prompts you for a
username and password.
• Use the copy scp EW_archive command to upgrade the Java applet for Avaya Branch
Gateway Manager software from an SCP server
• Use the copy scp module command, followed by the module number of the module you
want to upgrade, to upgrade the firmware on a media module from an SCP server
• Use the copy scp SW_imageA command to upgrade the Branch Gateway firmware into
Bank A from an SCP server
CLI commands for upgrading Branch Gateway firmware via SCP
July 2018 Deploying and Upgrading Avaya G430 Branch Gateway 91
Comments on this document? infodev@avaya.com