Telephone connections
To connect a new telephone, see the following sections:
• Connecting an IP telephone on page 45
• Connecting an analog telephone on page 46
•
Connecting a DCP telephone to an MM312, MM712, or MM717 media module on page 48
Configuration of telephones on Communication Manager
Standalone:
• Configuration may be performed on site by connecting a laptop computer to the Services port
of the Branch Gateway or S8300, or remotely via a modem connected to the Branch
Gateway or S8300, or remotely over the network.
• LSP: Configuration is done on the primary Communication Manager server.
For information about connecting a laptop to the Services port, see Connecting a computer to the
Services port. For information about preparing a modem, see Chapter 4: Connecting and enabling
a modem for remote access. For information about configuration, see Branch Gateway
configuration on page 55.
Telephone information recordings for software configuration
When you add a new telephone - IP, DCP or Analog - note the following information for software
configuration:
• Name and location of the owner of the telephone
• Model number of the telephone
• Extension of the telephone
• Slot and port number on the Branch Gateway to which the telephone connects — this does
not apply to IP telephones.
Testing the telephone
Procedure
1. Make outgoing calls from the telephone.
Make sure you hear a dial tone when you pick up the receiver. Make sure you can make
both an internal (within the local network) and an external (outside of the local network)
call.
2. Make a call to the telephone from both within the network and outside of the network.
Trunk additions
You must order, connect, configure, and test the trunk before adding the trunk to the Branch
Gateway.
Media module and device additions
July 2018 Deploying and Upgrading Avaya G430 Branch Gateway 63
Comments on this document? infodev@avaya.com
To Next Page
Loading...
