Upgrading Branch Gateway firmware using the CLI via a USB
device
About this task
You can upgrade firmware via a USB mass storage device using the CLI. The upgrade files must
first be downloaded to a local PC.
Procedure
1. Prepare installation worksheets.
See
Preparing installation worksheets on page 82.
2. Download the firmware files to a PC.
See Downloading Branch Gateway firmware files to a local PC on page 89.
3. Insert a USB mass storage device into the PC’s USB port, and copy the firmware files to
the USB mass storage device.
4. Remove the USB mass storage device from the PC, and insert it into the Branch Gateway
USB port.
5. Run CLI commands to copy the firmware files from the USB mass storage device to the
Branch Gateway.
See
CLI commands for upgrading Branch Gateway firmware via a USB device on
page 88.
CLI commands for upgrading Branch Gateway firmware via a USB device
You can use CLI commands to upload an upgrade file from a USB mass storage device to the
Branch Gateway. You must use the specific path to the file on the USB mass storage device.
• Use the copy usb EW_archive command to upgrade the Java applet for Avaya Gxxx
Manager software from a USB mass storage device
• Use the copy usb module command, followed by the slot number of the module you want
to upgrade, to upgrade the firmware on a media module from a USB mass storage device
• Use the copy usb SW_imageA command to upgrade the Branch Gateway firmware into
Bank A from a USB mass storage device
• Use the copy usb SW_imageB command to upgrade the Branch Gateway firmware into
Bank B from a USB mass storage device
Example upgrade using the CLI via a USB device
To upgrade the firmware of an MM712 media module in slot 3 from a USB mass storage device
where the upgrade file is located in the directory \temp\, use the following command:
copy usb module usbdevice0 \temp\mm712v51.fdl 3
Upgrading the Branch Gateway firmware
July 2018 Deploying and Upgrading Avaya G430 Branch Gateway 88
Comments on this document? infodev@avaya.com
To Next Page
