Chapter 5: Connecting and enabling a USB
modem for remote access
Connecting and enabling a USB modem for remote access
About this task
You can connect a USB modem to the Branch Gateway to enable configuration from a remote
location.
If an S8300D or S8300E server is installed in the Branch Gateway, leave a modem connected
permanently to enable reporting of alarms to remote locations.
For information about how to configure a USB or serial modem, see CLI and Gateway
Administration guides.
July 2018 Deploying and Upgrading Avaya G430 Branch Gateway 54
Comments on this document? infodev@avaya.com
To Next Page
