COMPACT FLASH MEMORY
--------------------
Type : 2.0 GB
Serial Number : STI1M2a407200161753
Model Number : STI Flash 8.0.0
Faults : OK
Compact flash memory card removals
After installing a compact flash memory card, you may decide to remove it for one of several
reasons. The following sections provide instructions for safe removal of a compact flash memory
card in each possible scenario.
• Replacing a compact flash memory card with a different compact flash memory card on
page 76 holding a different set of announcements
• Replacing a compact flash memory card while retaining The current announcements on
page 77. You may wish to do this because the current compact flash memory card failed, or
you want to have two copies of the announcement files, or you want to use a faster compact
flash card.
•
Downgrading from a compact flash to internal flash memory on page 77
Swapping compact flash memory cards
Procedure
1. At the SAT interface of the Communication Manager, enter disable announcement-
board.
Important:
If you do not enter the SAT command disable announcement-board, then, when
you insert the new compact flash, its contents will be overwritten by the contents of the
old compact flash.
2. Make sure the yellow CARD IN USE LED associated with the compact flash is not flashing.
Warning:
If a compact flash is removed while it is in use, the announcement files on the compact
flash may become corrupted and the Branch Gateway may reset, causing all
announcement files in RAM to be lost.
3. Remove the compact flash memory card.
4. Insert the new compact flash memory card into the compact flash slot.
5. At the SAT interface of the Communication Manager, enter enable announcement-
board.
Upgrading and replacing Field Replaceable Units
July 2018 Deploying and Upgrading Avaya G430 Branch Gateway 76
Comments on this document? infodev@avaya.com
To Next Page
Loading...
