copy tftp module \version\mm712v51.fdl 192.1.1.10 3
The following example downloads a firmware version with the path and file name C:
\g430_sw_37_38_0.bin.net from an FTP server with the IP address 149.49.134.153 to Bank A of
the Branch Gateway:
copy ftp SW_imageA C:\g430_sw_37_38_0.bin 149.49.134.153
Note:
The above specified path is the FTP server directory. Set the boot bank location for the new
firmware as per your customized configuration, and reboot the gateway.
See Avaya Branch Gateway G430 CLI Reference guide for a list of all commands for the
gateway.
Installation worksheets
Before you perform the upgrade, you must enter the names of the target software and firmware
versions that you need to install in the software and firmware upgrade worksheet. If you will need
to set up a TFTP server, you also need to plan the TFTP server IP address, login, and password.
Server Values worksheet
Table 8: Software and firmware upgrade file names
Items for Upgrading
New file name for target
File for LSP and primary controller (not used for individual
files)
Branch Gateway Processor
Branch Gateway Device Manager
MM710 E1/T1 media module
MM710B E1/T1 media module
MM711 Analog Port media module
MM712 DCP media module
MM714 Analog Port/Trunk media module
MM714B Analog Port/Trunk media module
MM716 Analog Port/Trunk media module
MM717 24-port DCP media module
MM720 BRI media module
MM721 BRI media module
MM722 BRI Trunk media module
Upgrading the Branch Gateway firmware
July 2018 Deploying and Upgrading Avaya G430 Branch Gateway 82
Comments on this document? infodev@avaya.com
To Next Page
Loading...
