Avaya G430 - Page 83

TFTP Server worksheet
Table 9: Global Settings for TFTP Server
TFTP Server IP Address TFTP Server Directory
TFTP server setup
To load single firmware files on an Branch Gateway, you must put the files on a computer
connected to the customer’s LAN in the customer’s network. You log on to the Branch Gateway
later and use the gateway's TFTP capability to download the new firmware. Set up a TFTP server
on the LAN.
Note:
Use a Linux or Unix TFTP server only if a Linux or Unix TFTP server already exists on the
local network. In this case, download the appropriate files to your laptop and give it to the
customer for proper placement and execution.
Downloading Branch Gateway firmware files to a local TFTP server
Procedure
1. Access the
www.avaya.com/support website.
2. Navigate to Media Gateway downloads.
3. Locate the file names that match the files listed in your installation worksheet.
See Sample software and firmware filenames on page 84 for sample firmware file names.
4. Double-click the file name of the file you want to download.
A File Download window appears.
Note:
Downloading files can occasionally add a [1] to the file name. Rename the file if
necessary.
5. Select Save this file to disk.
6. Save the file to directory on the TFTP server on the local LAN that was created for this
purpose.
See Setting up a TFTP server on page 83.
Result
Note:
If you are performing the upgrade using the Branch Gateway’s Command Line Interface (CLI),
you can place the upgrade files on an FTP server.
Branch Gateway firmware upgrades
July 2018 Deploying and Upgrading Avaya G430 Branch Gateway 83
Comments on this document? infodev@avaya.com