Procedure
1. Prepare a laptop with SSH client software.
2. Set the laptop's TCP/IP properties as follows:
• IP address: 192.11.13.5
• Subnet mask: 255.255.255.252
• Disable DNS service
• Disable WINS Resolution
3. Connect the laptop computer to the Branch Gateway Services port, using an Ethernet
cable.
4. SSH to 192.11.13.6.
5. At the prompt, enter the default login credentials.
6. At the prompt, configure a new password.
7. At the Enhanced Access Security Gateway (EASG) prompt, read the following message:
*****************************************************
Enhanced Access Security Gateway (EASG) Confirmation.
*****************************************************
Please confirm whether Avaya is granted login access this system.
You may change this setting any time after confirmation is
completed.
Enable EASG: (Recommended)
By enabling Avaya Logins you are granting Avaya access to your
system.
This is necessary to maximize the performance and value of you
Avaya
support entitlements, allowing Avaya to resolve product issues in a
timely manner.
In addition to enabling the Avaya Logins, this product should be
registered with Avaya and technically onboarded for remote
connectivity
and alarming. Please see the Avaya support site
(support.avaya.com/registration) for additional information for
registering products and establishing remote access and alarming.
Disable EASG:
By disabling Avaya Logins you are preventing Avaya access to your
system.
This is not recommended, as it impacts Avaya’s ability to provide
support
for the product. Unless the customer is well versed in managing the
product themselves, Avaya Logins should not be disabled.
Enter 1 to Enable EASG (Recommended) or 2 to Disable EASG? 1
8. At the prompt, enter 1 or 2 to enable or disable EASG.
The following message is displayed:
Branch Gateway configuration
July 2018 Deploying and Upgrading Avaya G430 Branch Gateway 56
Comments on this document? infodev@avaya.com
To Next Page
Loading...
