Testing the trunk
Procedure
1. Make outgoing calls from the trunk.
Ask the technician that is performing or supervising the configuration for instructions how
to access the trunk. Make sure you can make both an internal (within the local network)
and an external (outside of the local network) call.
2. Make a call into the Branch Gateway trunk.
Broadband line additions
You must order, connect, configure and test the Broadband line (xDSL or cable modem) before
adding the line to the Branch Gateway.
Broadband line ordering
If you need to order the Broadband line, make sure that the service provider installs the line near
the physical location of the Branch Gateway and verifies that the line is working before you
configure the WAN on the Branch Gateway.
Broadband line connections
Connect a Broadband line.
Broadband line configuration
Configuration may be performed on site by connecting a laptop computer to the Services port of
the Branch Gateway, or remotely via a modem connected to the Branch Gateway or S8300, or
remotely over the network.
For information about connecting a laptop to the Services port, see Connecting a computer to the
Services port. For information about preparing a modem, see Chapter 4: Connecting and enabling
a USB modem for remote access on page 54. For information about configuration, see Chapter 5:
Configuring the Branch Gateway on page 55.
Testing the Broadband link
About this task
After installation of the Broadband line is complete, test the link by pinging the Branch Gateway
WAN FastEthernet IP address, and performing a trace route test in order to test connectivity with
the network and outside the network.
Avaya Partner Contact Closure Adjunct additions
To install an Avaya Partner Contact Closure Adjunct, follow the instructions in
Installing the Avaya
Partner Contact Closure Adjunct on page 53.
Media module and device additions
July 2018 Deploying and Upgrading Avaya G430 Branch Gateway 65
Comments on this document? infodev@avaya.com
To Next Page
Loading...
