Avaya G700 - Page 448

448 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Configure the G700 Media
Gateway on page 497
- Assign IP addresses to the G700 processors
- Set up IP routing for the stack
- Set up default IP route for the G700
- Check IP connections
- Set up controller list for the G700
- Configure X330 Expansion Module, if
necessary
Install New Firmware on the
G700 on page 506
- Verify contents of the tftp directory
- Determine which firmware to install
- Install firmware on the P330 stack processor
- Install firmware on the G700 media gateway
processor
- Install firmware on the media modules
- Install firmware on other G700s in the stack or
network, if any
-Set Rapid Spanning Tree
Administer Communication
Manager on page 516
- Reboot the system
- Assign node names, if necessary
- Administer network regions
- Assign LSPs to network regions
- Administer IP interfaces
- Administer the LSP form
- Add media gateway
- Verify changes
- Enable announcements, if necessary
- Save translations
Considerations for IP Phones
Supported by a Local Survivable
Processor on page 536
Set Up SNMP Alarming on the
G700 on page 537
Complete the Installation of the
S8300 (if the Primary
Controller) on page 541
- Register the system
- Back up the system
- Check planning documentation
- Connect and administer test endpoints
- Complete electrical installation
- Enable adjunct systems
Checklist 1: Manually install new G700 with an S8300 (Primary or LSP) (continued)
Major Tasks Subtasks
2 of 3