Avaya G700 - Configure the G700

Manual installation of a new G700 without an S8300
550 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
4. Double-click the file name.
The system displays a File Download window.
5. Click on Save this file to disk.
6. Save the file to the C:\tftp directory (or your alternate tftp location).
7. Use WinZip or another zip file tool to unzip the file, if necessary.
Configure the G700
For a new installation of a G700 Media Gateway, you must complete the following configuration
tasks:
1. Assigning the IP addresses of the G700 media gateway components
2. Setting up the controller list for the G700
8-port/trunk Analog Media Module
(version 6 or earlier)
mm711<version id> mm711v17.fdl
8-port/trunk Analog Media Module
(version 7)
mm711<version id> mm711h7v24.fdl
8-port/trunk Analog Media Module
(version 20 or later)
mm711<version id> mm711h20v68.fdl
4-station/4-CO trunk Analog
Media Module
mm714<version id> mm714v67.fdl
T1/E1 Media Module mm710<version id> mm710v14.fdl
8-port BRI Media Module mm720<version id> mm720v6.fdl
2-port BRI Media Module mm722<version id> mm722v2.fdl
Table 35: Firmware file formats (continued)
Component Firmware Version
Format
Example
2 of 2