Manual installation of a new G700 with an S8300
526 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
IP Network Region Screen, Page 3
4. Type the number for the type of codec set (1–7) that the S8400, S8500, or S8700-series
Media Server will use to interconnect the G700 and the C-LAN board(s) in the row
corresponding to the region of the C-LAN.
In this example, the C-LAN is in region 9 and codec-set type 3 is to be used for the
interconnection between region 1 and region 9. (In this example, codec type 1 is used for
communication within region 1)
The SAT command, list ip-codec-set, lists the types of codecs available on this server.
For more detail about the Inter Network Region Connection Management form, see
Administration for Network Connectivity for Avaya Communication Manager, 555-233-504.
5. Press F3 (Enter) when complete.
Assigning LSPs to the Network Regions
If the primary controller has LSPs, you can assign the LSPs to network regions. In the event of
a network failure, IP telephones assigned to a network region will register with the LSPs
assigned to that region.
This procedure assigns up to six LSPs to a network region.
display ip-network-region 1 Page 3 of 19
Inter Network Region Connection Management
src dst codec direct Dynamic CAC
rgn rgn set WAN WAN-BW-limints Intervening-regions Gateway IGAR
11 1
12
13
14
15
16
17
18
19 3
110
111
112
113
114
115
To Next Page
Loading...
