Avaya G700 - Assigning Node Names and IP Addresses for the C-Lans and Lsps

Administer Communication Manager
Issue 9.1 June 2006 575
Note:
Note: For information on installing the CLAN boards on the S8400, S8500, or
S8700-series Media Server port networks and complete information on installing
an S8400, S8500, or S8700-series Media Server, see the Installation
documentation on the Documentation for Avaya Communication Manager, Media
Gateways and Servers CD, 03-300151.
Assigning Node Names and IP Addresses for the C-LANs and LSPs
Note:
Note: The CLAN boards must be TN799DP running version 5 or greater firmware. Be
sure to check the firmware version for these boards on the S8400, S8500, or
S8700-series Media Server. For information on how to upgrade the firmware on
the C-LAN circuit pack, please see the "Upgrading firmware on programmable
TN circuit packs," in Upgrading, Migrating, and Converting Avaya Media Servers
and Gateways,
03-300412.
To assign node names and IP addresses
1. At the SAT prompt, type change node-names ip to open the Node Names screen.
Example Node Names Screen
2. Enter the name and IP address for the C-LANs and LSPs.
3. Press F3 (Enter) when complete.
change node-names ip Page 1 of 1
IP NODE NAMES
Name IP Address Name IP Address
default_________ 0__.0__.0__.0__ _______________ ___.___.___.___
node-1-clan __
192.168.1 _.124 _______________ ___.___.___.___
node-2-clan 192.168.1 _.97_ _______________ ___.___.___.___
node-10-lsp 192.168.1 _.50_ _______________ ___.___.___.___
node-11-lsp
192.168.1 _.51_ _______________ ___.___.___.___
__________ ___.___.___. _ _______________ ___.___.___.___
__________ ___.___.___. _ _______________ ___.___.___.___
_____
_____ ___.___.___. _ _______________ ___.___.___.___