When network configuration is Auto, every time the phone restarts, it will connect to the pre-
configured network that your administrator has set up.
When network configuration is Manual, every time the phone restarts, it will connect to the network
that you manually configured by Setting the network mode on page 25 or Connecting to a Wi-Fi
network on page 26, irrespective of the pre-configured network that your administrator has set up.
Note:
Any time you manually change the connected network, the phone will automatically set
Network config to Manual.
Procedure
1. Press the Main menu.
2. Scroll to Settings and press Select.
3. Scroll to Network and press Select.
4. Scroll to Network config.
The Network configuration shows following two options:
• Auto: To automatically connect a network.
• Manual: To manually connect to a network.
5. Press one of the following:
• Toggle
• Right arrow key
• Left arrow key
6. Press one of the following:
• Save
• OK
Note:
If you do not want your phone to restart and stay in the Manual mode when you switch
Network config from Auto to Manual, press Save.
If you switch Network config from Manual to Auto, press Save and then do either of
the following:
• If the currently-connected network is the same as the pre-configured network that
your administrator has set up, the phone will not restart and stay in the Auto mode.
• If the currently-connected network is not the same as the pre-configured network
that your administrator has set up, the phone will prompt you for permission to
restart before connecting to the pre-configured network.
Setting the network mode
April 2021 Using Avaya J189 SIP IP Phone in Open SIP 27
Comments on this document? infodev@avaya.com
To Next Page
Loading...
