Avery Dennison AP5.4 Gen II - Data Synch; Frame Error; Com3 Port; Baud Rate

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP5.4 Gen II – AP5.6
41
Data synch.
AP5.4 AP5.6
Data synchronisation at the serial interface.
RTS/CTS Data synchronisation through hardware
XON/XOFF Data synchronisation through software
None Handshake signals are ignored
Frame error
AP5.4 AP5.6
Display (Default) An error message is displayed, if a framing error is detected while
the printer is receiving serial data.
Ignore Framing errors will be ignored, no error messages are displayed.
> COM3 PORT
¯ This menu only appears, if the optional I/O board is installed.
Baud rate
AP5.4 AP5.6
¯ With mounted and connected I/O board only.
P See parameter Baud rate  on page 45.
No. of data bits
AP5.4 AP5.6
¯ With mounted and connected I/O board only.
P See parameter No. of data bits  on page 45.
Parity
AP5.4 AP5.6
¯ With mounted and connected I/O board only.
P See parameter Parity  on page 45.