Avery Dennison AP5.4 Gen II - Head Strobes; Head Temperature; Foil Diameter; Dispensing Cycl

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP5.4 Gen II – AP5.6
99
Head strobes
AP5.4 AP5.6
Shows the counted head strobes, which are a measure for the service life of
the printhead. A strobe is counted for each line in which at least one dot ist
printed. Maximum value: 4 billions.
Head temperature
AP5.4 AP5.6
Shows the current printhead temperature in °C.
Foil diameter
AP5.4 AP5.6
Shows the calculated foil diameter: A measurement routine calculates the ac-
tual ribbon roll diameter with an exactness of 7.5%.
The parameter
SYSTEM PARAMETER > Foil end warning can be used to set a critical
foil roll diameter. If the foil roll diameter equals this value, a message appears
on the printer display.
P See parameter Foil end warning  on page 68.
Dispensing cycl.
(Dispensing cycles)
AP5.4 AP5.6
¯ AP5.4/5.6: Dispenser version only.
Shows the number of dispensed labels.
Operation time
AP5.4 AP5.6
Shows the elapsed time since the last switch-on of the machine.