Chapter 4: Managing Units 83
6. The Select Appliance to Add window will open. Select the entry, then click Next.
7. The Select Options window will open. (This window will not appear when adding a CCM
appliance that is using firmware compatible with AVWorks software; see Task: Migrating
AVWorks software CCM appliances to DSView software compatible units on page 254 for
more information.)
a. Click Enable secure mode if you want the managed appliance to only be accessible by
this DSView software system. In non-secure mode, the managed appliance may be added
to multiple DSView software systems.
This checkbox will not appear when adding a DSI5100 appliance, which may only be
added in Secure mode.
b. Click Prevent target devices that contain default names from being added if you wish to
prevent the adding of any target devices whose port names have not been modified from
the factory defaults of the managed appliance.
This checkbox has no effect when adding a DSI5100 appliance, since default target device
names are not supported. A target device is named when it is added as a BMC port using
the Add IPMI BMC Wizard.
c. Click Allow target devices with the same name to be merged into a single target device if
you wish to merge a target device that has multiple connections into a single target device.
For example, a target device may be connected to a both a DSR switch and an SPC device
outlet connected to a CPS appliance.
d. Click Next.
If you are adding a DS1800 digital switch, CPS or CCM appliance or DSR switch,
continue to step 7.
-or-
If you are adding a DSI5100 appliance, go to step 8.
8. If one or more cascade switches are connected to the managed appliance, the Configure
Cascade Switches window will open.
a. Select the type of cascade switch for each row from the drop-down menu in the Cascade
Switch Type column.
b. If you wish, type a name for each row in the Name column.
c. If two or more rows of a multiuser cascade switch are discovered, you may merge the
rows by selecting the checkboxes of those rows and clicking Merge. To undo the merge,
click the row of the merged switch and click Split.
d. Click Next.
9. The Completed Successful window will open.
When you add a CCM appliance that is using firmware compatible with AVWorks software,
you will be alerted that it must be migrated, along with a link named Add Migration Task,
which will take you to the Add Task Wizard.
To Next Page
Loading...