Avocent DSView - Displaying the Details of Audit Log Events; Deleting Audit Log Events; Enabling and Disabling Audit Log Events

Chapter 10: Audit Logs 273
Displaying the Details of Audit Log Events
You may display all logged information about a specific audit log event.
To display the details of an event in the audit log:
1. From an Audit Log window, click on the link in the Severity column for which you wish to
display details. The Audit Log Event Information window will open and contain information
about the audit log entry.
NOTE: Trap Enterprise in the Audit Log-All window is named Enterprise OID in the Audit Log Event
Information window.
2. Click Close. The Audit Log window will open.
Deleting Audit Log Events
To delete an event from the audit log:
1. From an Audit Log window, click the checkbox to the left of the event(s) you wish to delete.
-or-
Click the checkbox to the left of Severity at the top of the list to select all events listed in the
window for deletion.
2. Click Delete. A confirmation dialog box will appear.
3. Click OK to delete the event(s).
-or-
Click Cancel to cancel the action.
Enabling and Disabling Audit Log Events
Events occurring on your DSView software system may be disabled using the Enabled Audit Log
Events window. When an event is disabled, its state will appear as Disabled and the event will not
be logged until it is reenabled. An event may be reenabled by selecting it and clicking Enable.
You may change the number of items that display in the Enabled Audit Log Events window by
clicking the Customize link. See Using the Customize link in windows on page 14 for
more information.
To enable or disable an event in the audit log:
1. From the side navigation bar, click Enabled Events. The Enabled Audit Log Events window
will open and display a listing of all enabled and disabled audit log events.
2. Click the checkbox to the left of an enabled event you wish to disable or a disabled event you
wish to enable.
-or-