Chapter 4: Managing Units 91
6. Select the DSView software server that is in charge of the target device.
7. Click Save to save your changes.
8. Click Close. The Unit Views window will open, including any changes.
To change the network properties of a managed appliance:
NOTE: This procedure is valid for the following managed appliances: DS1800 switches, DSI5100 appliances,
CPS appliances, CCM appliances and DSR switches.
1. From the side navigation bar, click Properties.
2. From the side navigation bar, click Network. The Unit Network Properties window will open.
3. Type the address or the fully qualified domain name.
4. Select the DSView software server in charge of the managed appliance.
5. Click Save to save your changes.
6. Click Close. The Unit Views window will open, including any changes.
To change the network properties of an EVR1500 environmental monitor or
generic appliance:
1. From the side navigation bar, click Properties.
2. From the side navigation bar, click Network. The Unit Network Properties window will open.
3. Type the address or the fully qualified domain name.
4. Type a Telnet port number.
5. Type a web browser address.
6. Select the DSView software server in charge of the EVR1500 environmental monitor or
generic appliance.
7. Click Save to save your changes.
8. Click Close. The Unit Views window will open, including any changes.
Changing Unit Access Rights
You may specify whether users or users belonging to a particular group have permission to:
• Establish a Video Viewer session on target devices
• Power up, power down or cycle the power of target devices
• Establish virtual media sessions to target devices
• Establish reserved virtual media sessions to target devices
Additionally, you may specify whether a user or user group has permission to perform the
following actions on a DS1800 digital switch, DSI5100, CPS or CCM appliance or DSR switch:
• Reboot the appliance and/or disconnect sessions
• Upgrade the firmware (Flash)
To Next Page
Loading...