90 DSView Installer/User Guide
To change the contact properties of a unit:
NOTE: Contact properties should be kept up-to-date.
1. From the side navigation bar, click Properties.
2. From the side navigation bar, click Contacts. The Unit Contacts window will open.
3. Type the name of the primary contact.
4. Type the phone number of the primary contact.
5. Type the name of the secondary contact.
6. Type the phone number of the secondary contact.
7. Click Save to save your changes.
8. Click Close. The Unit Views window will open, including any changes.
To change the custom fields of a unit:
1. From the side navigation bar, click Properties.
2. From the side navigation bar, click Custom Fields. The Unit Custom Fields window will open.
3. Type the information in each of the three custom fields.
4. Click Save to save your changes.
5. Click Close. The Unit Views window will open, including any changes.
To change the note properties of a unit:
1. From the side navigation bar, click Properties.
2. From the side navigation bar, click Notes. The Unit Notes window will open.
3. Type description information.
4. Type accounting information.
5. Type comments.
6. Click Save to save your changes.
7. Click Close. The Unit Views window will open, including any changes.
To change the network properties of a target device:
NOTE: Defining incorrect information for these properties may cause network connection errors.
1. From the side navigation bar, click Properties.
2. From the side navigation bar, click Network. The Unit Network Properties window will open.
3. Type the address or the fully qualified domain name for the target device.
4. Type the Telnet port number to use for Telnet connections to the target device. If this field is
left blank, Telnet will not be enabled for the target device.
5. Type the URL for a web browser connection to the target device.
To Next Page
Loading...