220 DSView Installer/User Guide
Table 8.2 describes the status icons that may appear in the IPMI Viewer window.
Gauges may also contain color areas at their upper and lower thresholds, as listed in Table 8.3.
In Figure 8.2, the temperature gauge contains threshold values of approximately 5.0-9.25 at its
lower threshold and approximately 43.25-47.5 at its upper threshold.
NOTE: Unsupported numeric sensor thresholds will not appear in the IPMI Viewer window.
E
IPMI Viewer display area: Contains gauges that display numeric readings from the
BMC sensors in the IPMI 1.5 target device. Depending on the sensors on the BMC,
any of the following gauges may appear in the IPMI Viewer window:
Voltage - The voltages in the IPMI 1.5 target device.
Current - The currents in the IPMI 1.5 target device.
Fans - The revolutions per minute (RPM) of each fan in the target device.
Temperature - The temperatures in the IPMI 1.5 target device, in degrees
Celsius, including ambient, planar and riser temperature.
Each gauge contains a status icon to its upper left, see Table 8.2
Table 8.2: IPMI Viewer Window Status Icons
Icon Description
(green circle) The current value is within acceptable threshold values.
(grey circle) The current value is unknown.
(yellow exclamation) The current value is in the non-critical area.
(red x) The current value is in the critical area.
(dark red sad face) The current value is in the non-recoverable area.
Table 8.3: Upper and Lower Threshold Gauge Colors
Color Description
Yellow Non-critical threshold values
Red Critical threshold values
Dark red Non-recoverable threshold values
Table 8.1: IPMI Viewer Window Descriptions (Continued)
Letter Description
To Next Page
Loading...