96 DSView Installer/User Guide
10. Click Close. The Unit Views window will open.
To change the IP addresses of authentication servers:
NOTE: Except as noted, this procedure is valid for the following managed appliances: DS1800 digital switches,
CPS appliances, CCM appliances and DSR switches.
1. From the side navigation bar, click Appliance Settings.
2. Under Appliance Settings in the side navigation bar, click Authentication Servers. The
Appliance Authentication Servers Settings window will open.
3. Type an IP address, in standard dot notation (xx.xx.xx.xx), for up to four
authentication servers.
4. Click Save to save your changes.
5. Click Close. The Unit Views window will open.
To display NFS status or change the NFS settings for a CCM appliance:
1. From the side navigation bar, click Appliance Settings.
2. Under Appliance Settings in the side navigation bar, click NFS. The Appliance NFS Settings
window will open.
3. To enable NFS on the appliance, click the Enable NFS checkbox. To disable NFS, uncheck it.
When you enable NFS, you may also configure the following information:
a. Type an address in the NFS Server field.
b. Type the mount point in the NFS Mount Point field.
c. Select the protocol to be used from the Protocol drop-down menu.
d. Choose the log file rotation type by enabling one of the radio buttons Do not rotate.
Append data to end of file or Create new file each day at midnight.
4. Click Save to save your changes.
The NFS Status section of the Appliance NFS Settings window may contain one of the values
described in Table 4.3.
Table 4.3: CCM Appliance NFS Status Values
Status Description
Not mounted NFS is not currently enabled.
Mounted NFS is currently enabled and is currently successfully mounted.
Mounting
NFS is currently enabled and the mount is being attempted for the first time.
The mount has not yet succeeded or failed.
Mount attempt
failed (retrying)
NFS is currently enabled, but a mount failure has occurred and the mount is
currently being retried.
To Next Page
Loading...