172 DSView Installer/User Guide
To enter single cursor mode:
Select Tools - Single Cursor Mode. The local cursor will not appear and all movements will be
relative to the target device.
-or-
Click the Single Cursor Mode button.
To select a key for exiting single cursor mode:
1. Select Tools - Session Options from the Video Viewer window menu.
-or-
Click the Session Options button.
The Session Options dialog box appears.
2. Click the Mouse tab.
3. Select a terminating keystroke from the drop-down menu in the Single Cursor mode area.
4. Click OK. When you enable Single Cursor mode, the specified key may be pressed to return to
Regular Desktop mode.
To exit single cursor mode:
Press the key on the keyboard that is identified in the title bar.
Cursor settings
When using the DSView management software, your mouse pointer will change shape when over a
Video Viewer window. You may change the appearance of this second local cursor or eliminate it
from within the DSView management software.
Scaling
You may choose among three preconfigured mouse scaling options or set your own custom scaling.
The preconfigured settings are: Default (1:1), High (2:1) or Low (1:2), as follows:
• In a 1:1 scaling ratio, every mouse movement on the desktop window will send an equivalent
mouse movement to the server.
• In a 2:1 scaling ratio, the same mouse movement will send a 2X mouse movement.
• In a 1:2 scaling ratio, the value will be 1/2X.
Alignment
Because the DSView management software cannot get constant feedback from the mouse, there are
times when the mouse on the DS1800 digital switch or DSR switch may lose sync with the mouse
on the host system. If your mouse or keyboard no longer responds properly, you may align the
mouse to re-establish proper tracking.
To Next Page
Loading...