Chapter 4: Managing Units 85
This checkbox has no effect when adding a DSI5100 appliance, since default target device
names are not supported. A target device is named when it is added as a BMC port using
the Add IPMI BMC Wizard.
c. Click Allow target devices with the same name to be merged into a single target device if
you wish to merge a target device that has multiple connections into a single target device.
For example, a target device may be connected to a both a DSR switch and an SPC device
outlet connected to a CPS appliance.
d. Click Next.
7. The Adding Appliances window will open while the selected managed appliances are added to
the DSView software system.
8. The Completed Successful window will open.
When you add a CCM appliance that is using firmware compatible with AVWorks software,
you will be alerted that it must be migrated, along with a link named Add Migration Task,
which will take you to the Add Task Wizard.
9. Click Finish.
To add a single EVR1500 environmental monitor or generic appliance:
1. Click Add in the Unit Views window. The Add Unit Wizard will open. Click Next.
2. The Select Add Unit Procedure window will open. Click Add a single appliance, then
click Next.
3. The Select Appliance Type window will open. Select EVR1500 or Generic from the product
list, then click Next.
4. A Configure Generic Appliance Settings window will open, including the name of the
EVR1500 environmental monitor or generic appliance.
a. Type the name.
b. (Optional) Type either the address or the fully qualified domain name.
c. (Optional) Type the Telnet port.
d. (Optional) Type the web browser URL.
e. Click Next.
5. The Completed Successful window will open.
6. Click Finish.
To add a target device:
1. Click Add in a Unit Views window. The Add Unit Wizard will open. Click Next.
2. The Select Add Unit Procedure window will open. Click Add a single target device.
Click Next.
3. The Type in Device Settings window will open, where you may type the name and other
optional information.
To Next Page
Loading...