94 DSView Installer/User Guide
d. Control Target Device Power - enables the user or members of the user group to power
up, power down or cycle power to the target device.
5. Repeat steps 3 and 4 to change access rights for other users or user groups.
6. Click Save to save your changes.
7. Click Close. The Unit Views window will open. If enabled, a KVM Session, Virtual Media
Session or Serial Session link will appear in the Action column. If enabled, a power control
option will appear in the Unit Overview window.
To change the unit access rights of managed appliances:
NOTE: Except as noted, this procedure is valid on the following managed appliances: DS1800 digital switches,
DSI5100 appliances, CPS appliances, CCM appliances and DSR switches.
1. From a Unit Views window:
To change the access rights for a single managed appliance, click on a managed appliance
name. Overview will automatically be selected in the side navigation bar and the Unit
Overview window will open. Continue to step 2.
-or-
To change the access rights for all managed appliances, click the Rights button. The Unit
Access Rights window will open. Go to step 3.
2. From the side navigation bar, click Access Rights. The Unit Access Rights window will open.
3. Select a user or group in the User and User Groups list.
4. Click on or more of the following:
a. Reboot Appliance and Disconnect Sessions - enables the user or members of the user
group to reboot the managed appliance and/or disconnect sessions.
b. Flash Upgrade Appliance - enables the user or members of the user group to upgrade the
managed appliance firmware.
c. Configure Unit Settings - enables user or members of the user group to configure managed
appliance settings.
d. Configure Appliance Local User Accounts - enables the user or members of the user group
to configure the account information of local users.
The Local User Accounts option is not valid for DSI5100 appliances, DS1800 digital
switches or DSR800, 1161, 2161 or 4160 switches, and will not appear in the Unit Access
Rights window.
5. Repeat steps 3 and 4 to change access rights for other users or user groups.
6. Click Save to save your changes.
7. Click Close. The Unit Views window will open.
To Next Page
Loading...