Chapter 4: Managing Units 99
5. Click Save to save your changes.
6. Click Close. The Unit Views window will open.
To specify SNMP community settings for a managed appliance:
1. From the side navigation bar, click Appliance Settings.
2. Under Appliance Settings, click SNMP.
3. Under SNMP, click Community. The Appliance SNMP Community Settings window
will open.
4. Type the SNMP community name for reading.
5. Type the SNMP community name for writing.
6. Type the SNMP community name for SNMP traps.
7. Click Save to save your changes.
8. Click Close. The Unit Views window will open.
To specify SNMP destination settings for a managed appliance:
1. From the side navigation bar, click Appliance Settings.
2. Under Appliance Settings, click SNMP.
3. Under SNMP, click Destinations. The Appliance SNMP Destination Settings window
will open.
4. Type the IP addresses, in standard dot notation (xx.xx.xx.xx), for up to four
SNMP destinations.
5. Click Save to save your changes.
6. Click Close. The Unit Views window will open.
To enable or disable SNMP traps for a managed appliance:
NOTE: SNMP traps may also be configured from a system task. See Managing Tasks on page 244 for
more information.
1. From the side navigation bar, click Appliance Settings.
2. Under Appliance Settings, click SNMP.
3. Under SNMP, click Traps. The Appliance SNMP Trap Settings window will open.
4. Select one of the following from the drop-down menu:
Enabled to turn a trap on or Disabled to turn a trap off.
-or-
Enable All to turn all traps on or Disable All to turn all traps off.
5. Click Save to save your changes.
6. Click Close. The Unit Views window will open.
To Next Page
Loading...