62 DSView Installer/User Guide
The Authentication Service Certificate Management window will open if only one
certificate was selected. If more than one certificate was selected, each will appear in
order in subsequent Accept SSL Certificate windows.
13. To unregister certificates:
a. To select one or more certificates, click the checkbox to the left of the server IP addresses.
-or-
b. To unregister all certificates, click the checkbox to the left of the IP Address heading.
c. Click the Unregister button to unregister the certificates.
d. A confirmation message box will appear. Click OK to unregister the server.
-or-
Click Cancel to cancel the action.
14. Click Close. The User Authentication Services window will open.
To change user browsing settings for Active Directory external
authentication services:
1. From the User Authentication Services window, click the name of the AD service. The side
navigation bar will change to include the name of the AD service at the top and, below the
name, the information you may define.
2. From the side navigation bar, click User Browsing. The Authentication Service User Browsing
- AD window will open.
3. Click Browse Anonymously to browse users on the external Active Directory
authentication server.
-or-
Click Browse with User Credentials to browse users on the external Active Directory
authentication based on credentials configured on the server. If this option is selected, do
the following:
a. Type the username for an Active Directory account that has browse rights in the User
Name field. The log in ID must be entered in case sensitive text if the Active Directory
server is set u to use Kerberos.
b. Type the password for an Active Directory account that has browse rights in the
Password field.
4. Click Save to save your changes.
5. Click Close. The User Authentication Services dialog box will appear.
To change connections for LDAP external authentication services:
1. From the User Authentication Services window, click the name of the LDAP service. The side
navigation bar will change to include the name of the LDAP service at the top and, below the
name, the information you may define.
To Next Page
Loading...