Chapter 3: DSView Software Servers 69
3. From the Spoke Servers window, click Certificate. The Spoke Server Certificate window will
open including information about the spoke server certificate (Actual Certificate) and the
certificate registered for this spoke server on the hub server (Registered Certificate).
4. The window displays the certificate on the spoke server and the certificate registered on the
hub server.
If the DSView management software cannot obtain the certificate information from the spoke
server, a message will appear at the bottom of the DSView Server Certificate - Spoke Server
window. The message states: Remote server is not responding. Information displayed may not
match remote side.
If the certificate information does not match, continue to step 5.
- or -
If the certificate information matches, go to step 6.
5. Click Update. The spoke server certificate information will be updated on the hub server.
6. Click Close. The Spoke Servers window will open.
To update the certificate of a hub server on the spoke server:
1. From the spoke server’s DSView Explorer, click System. DSView Server is automatically
selected in the top navigation bar and the name of the spoke server appears at the top of the
side navigation bar.
2. From the side navigation bar, click Hub Server. The Hub Server window will open.
3. From the hub Server window, click Certificate. The Hub Server Certificate window will open
including information about the spoke server certificate (Actual Certificate) and the certificate
registered for this spoke server on the hub server (Registered Certificate).
If the DSView software cannot obtain the certificate information from the hub server, a
message will appear at the bottom of the DSView Server Certificate - Hub Server window. The
message states: Remote server is not responding. Information displayed may not match
remote side.
If the certificate information does not match, continue to step 4.
4. Click Update. The hub server certificate information will be updated on the spoke server.
To delete a spoke server:
1. From the Spoke Servers window, click the checkbox to the left of the spoke servers you wish
to delete.
-or-
Click the checkbox to the left of Name at the top of the list to select all spoke servers listed in
the window for deletion.
2. Click Delete. A confirmation dialog box will appear.
3. Click OK to delete the spoke servers.
-or-
To Next Page
Loading...