Avtech AVZ217 - Clear Hard Disk

FOR INITIAL USE
10
SETUP WIZARD
DDNS ON
SYSTEM NAME Eagleeyes 
HOST NAME MAC000E533A3D
E-MAIL
CURRENT HOST ADDRESS
MAC000E533A3D4A.ddns.eagleeyes.tw
SKIP
PREV
NEXT
Enable DDNS if needed.
Note: To enable the DDNS later, please go to “ADVANCED CONFIG”  “NETWORK”  “DDNS”
(“NETWORK” at page 36).
3.2 Clear Hard Disk
When this device is powered on, hard disk detection will be on, and you’ll be prompted to clear the hard disk(s):
CLEAR HDD
CLEAR HDD HDD0
YES
NO
Please choose “YES” to clear the connected hard disk(s), or this device will not detect hard disks properly for
video recording.
It might take some time to clear the connected hard disk(s). When it’s done, you’ll see the remaining hard disk
capacity on the top right corner of the screen.
Note: It’s necessary to clear hard disks in order to format the connected disks to the right format to save
video data. The format used for this device can NOT be read directly on a PC. Please do not install
the hard disk directly to a PC and try to copy the video data saved in the hard disk. The video data
might be impaired.
To change later, right click to show the main menu, and select (SYSTEM)  “SYSTEM INFO”  “CLEAR
HDD”. The DVR will reboot when hard disk data are cleared.
SYSTEM
ACCOUNT
BAUD RATE 2400

TOOLS
HOST ID 000
SYSTEM INFO
R.E.T.R 5

BACKUP DATA
AUTO KEY LOCK(S) NEVER

BACKUP LOG
CLEAR HDD HDD-0

RESET DEFAULT SUBMIT
REMOTE CONTROL ID 000
DEVICE TITLE OFFICE
SERIAL TYPE RS485
VIDEO FORMAT NTSC
VERSION 1019-1008-1010-1010
EXIT