Avtech AVZ217 User Manual

MAIN MENU
50
6.5 SCHEDULE SETTING
6.5.1 RECORD / DETECTION / ALARM IN / ALARM OUT / PUSH VIDEO / BUZZER
Select the timer type you want to configure (RECORD / DETECTION / ALARM IN / ALARM OUT / PUSH VIDEO /
BUZZER), choose “ON” to enable the timer, and select the day and time for this function.
SCHEDULE SETTING
RECORD RECORD TIMER ON
DETECTION 0 2 4 6 8 10 12 14 16 18 20 22 24
ALARM IN SUN
ALARM OUT MON
PUSH VIDEO TUE
BUZZER WED
REGULAR REPORT THU
AUTO BACKUP FRI
REGULAR REBOOT SAT
EXIT
X axis
0 ~ 24 hours. Each time bar is 30 minutes.
Y axis
Monday ~ Sunday.
6.5.2 REGULAR REPORT
This function is used to send event reports to the specified E-mail address. Users could configure up to 5 profiles
to receive different reports about specific channels at different time.
Note: This function is available only when a hard disk is installed, and the DVR is connected to Internet.
SCHEDULE SETTING
RECORD PROFILE 1 
DETECTION ACTIVE ON
ALARM IN PERIOD DAILY 
ALARM OUT DAY OF MONTH 1
PUSH VIDEO HOUR 1 
BUZZER CHANNEL CH1 
REGULAR REPORT EVENT TYPE MOTION 
AUTO BACKUP E-MAIL SETUP
REGULAR REBOOT
EXIT
Step1: Select the profile you want to configure, and enable it.
Step2: Select the frequency to send reports in “PERIOD”: DAILY / MONTH / WEEK.
Step3: When MONTH or WEEK is selected, select which date or day from “DAY OF MONTH” or “DAY OF WEEK”.
Step4: Then, select which time you want to receive reports, which channel(s) you want to see, and which event
type(s) you want to see (ALARM / MANUAL / MOTION / SYSTEM / TIMER / INFLOW / OUTFLOW /
VIRTUAL FENCE / ONEWAY / SCENE CHANGE).
Step5: Configure the email address to receive reports.
Note: The sender E-mail should be configured in “ADVANCED CONFIG”  “NETWORK”  “E-MAIL” for
this function to work properly. For details, please refer to “E-MAIL” at page 36.

Avtech AVZ217 Specifications

General

Brand	Avtech
Model	AVZ217
Category	Security System
Language	English