FIRST INSTALLATION RECOMMENDATIONS |POWER SUPPLY CABLE
OXYGEN 3000 · User Manual · ENG
FIRST INSTALLATION RECOMMENDATIONS
POWER SUPPLY CABLE
A power supply cable of approx. 2 mt lengths is supplied with the device, which has a moulded IEC plug attached – this is a legal requirement.
The type of plug for the power supply depends on the country in which it is delivered.
If for any reason, you need to use this appliance with a different plug, you should use the following wiring guidelines in replacing the existing plug with the new one:
Green, or green and yellow
Supply cables should be laid in such a manner that one does not step or walk on them. They should not be squashed by any objects.
THIS EQUIPMENT MUST BE EARTHED.
The chassis is always connected to mains earth to ensure your safety: check your mains wiring and earthing before switching on.
PROTECTION AGAINST LIGHTNING
Should the device be put out of action due to being struck by lightning or excess voltage, disconnect it from
the power supply without delay. Do not reconnect until the device has been checked. If in doubt contact the
technical support service.
Make sure there is a suitable lightning protection to protect the device.
Alternatively, you should disconnect all connectors from the device during a storm or when the device is
going to be unsupervised or not used for a longer period of time.
These measures will protect against damage by lightning or excess voltage.
To Next Page
Loading...
Need help?
General
