PREAMP:
The preamplifier is typically used to amplify signals from analog sensors such as microphones. It allows you convert a weak signal for sending to a
power amplifier or loudspeakers without any noise or distortion.
This parameter changes the Input PREAMPLIFIER.
The parameter has a 0.5 dB step for maximum +60.0 dB.
N.B.: When you adjust the PREAMP parameter, you have a real-time change of the parameter value and the real-time perception of the PREAMP
change. The Graphics will become white to indicate the parameter change, and it will become yellow again after the confirmation.
To Next Page
Loading...
Need help?
General
