The CUT mode is triggered by the change from OFF to ON of a microphone source to which it has been set closing of the C-ROOM loudspeaker,
using the following to set this function:
As shown in the MENU this function (CUT) is associated only with the loudspeakers, this to avoid LARSEN effects “feedback loop” from
occurring between the nearby CR loudspeakers and On-Air microphones.
If you need to MUTE the loudspeakers just PUSH the volume knob.
PUSH the volume knob a second time or rotate it to activate Control Room loudspeakers output and amplification or attenuation.
The status of MUTE-SPK is indicated by a red cross on the SPEAKER icon and SPK button will start blinking.
To Next Page
Loading...
Need help?
General
