Axis SE-01 User Manual

ENGINEERING DOCUMENTATION 29
_____________________________________________________________________________________________
12.7 Average calculation function (AVErAG)
The function allows for calculating average value of performed measurement
series. During series of measurements successive results are registered
automatically when scale indication is stabilised.
Press MENU key and select AUErAG
pressing → T ← key.
The following will be shown
successively on display:
- AUEr-0 – leaving function,
- AUEr-1 – measurement with average
calculation..
Select AUEr-1. It will allow weighing
with simultaneous storing results into
summing register for average
calculation
Measurement registration is performed
automatically in the moment when
scale indication becomes stable. Short
time displaying of „ - - ” denotes that
load can be taken off and new one can
be put on. Results above scale Min are
registered only. Number of
measurements is limited to 9999.
In order to read average value key
should be used.
- first pressing causes displaying
number of measurements (n).
- second displaying causes displaying
average value (=).
- third pressing allows continuing
average calculation.
If a printer is connected to scale the
following report will be printed :
In
order to finish calculation press
MENU key, and then select AUEr i
AUEr-0.
Date: ... Time.
...
MEASUREMENS No = ...
AVERAGE VALUE = ...
0.00
0.00
AUErAG
AUEr- 1
1.00
2.00
2
1.50
_
_
0.00
0.00
MENU
T
T
n

Axis SE-01 Specifications

General

Brand	Axis
Model	SE-01
Category	Measuring Instruments
Language	English