Axis SE-01 - Function for Maximum Value Indication (UP)

ENGINEERING DOCUMENTATION 33
_____________________________________________________________________________________________
12.11 Function for maximum value indication (UP)
This function allows holding on display maximum value shown by the scale in a
while.
Before measurement scale should be
tared.
After using MENU key and selecting
UP function the highest mass result
will be hold on display.
Pressing → T ← key will cause result
zeroing.
Note:
Autozeroing function and the
stabilisation indicator are
deactivated when UP function is
running. Weighing result is
continuously averaged from 5
measurements.
0.00
UP
UP- 0
UP- 1
1.00
1g
1g
10.00
10.00
T
T