Need help?Do you have a question about the Ayecka SR1 and is the answer not in the manual?
Audience is IP over satellite communication professionals.
Introduces setup, config, monitoring, troubleshooting of SR1.
Specifies applicable SW and FW versions.
Provides contact for technical support.
Details the SR1's physical interfaces like GigE, RF, USB.
Explains the SR1's internal GigE switch architecture and ports.
Describes the optional Application CPU and its GigE interface.
Covers the optional ASI input/output interfaces.
Explains how SR1 integrates into IP over satellite topologies.
Illustrates the SR1's internal structure and components.
Details the management of SR1's receivers and configuration profiles.
Explains how SR1 forwards IP packets to the LAN.
Describes the SNMP MIB for configuration and monitoring.
Instructions on how to power up the SR1 device.
Describes the SR1's front panel interfaces and indicators.
Details the SR1's back panel interfaces, including RF inputs and status LEDs.
Outlines the overall steps for installing the SR1.
Lists parameters to be configured during installation.
Explains how to connect the necessary cables to the SR1.
Describes the serial over USB management interface.
Explains the Telnet over IP interface for management.
Explains how to navigate the Terminal Base User Interface.
Details the boot process and terminal display.
Describes the SR1's main menu structure and information displayed.
Covers configuration of receivers, demodulator, and de-capsulation.
Explains filter allocation to Rx1 and Rx2.
Configures SR1 for transport stream or base band frames.
Determines single or dual demodulator operation.
Configures automatic or manual RX channel switching.
Defines automatic or manual channel switching.
Sets the period for RX channel switching.
Allows manual selection of the active channel.
Enables configuration of reception, demodulation, and de-capsulation.
Manages configuration sets for RX channels.
Defines the profile switch period for configuration sets.
Sets configuration parameters for an active RX channel set.
Configures De-Capsulation filters (PID/MAC/IP/Multicast).
Sets parameters for specific filter records.
Displays status information for RX channels.
Configures networking parameters like IP addresses, gateway, and ARP.
Manages the Traffic interface ARP learning mechanism.
Manages the SR1's ARP table and settings.
Lists the internal ARP table of the SR1 Traffic interface.
Configures SR1 maintenance parameters like resets and upgrades.
Options for warm/cold reset and restoring factory defaults.
Configuration for Telnet username, password, and timeout.
Configures NTP, SNMP trap server, and community strings.
Selects types of event reports (Console, SNMP Trap).
Accesses the menu for upgrading the FPGA image.
Displays installed FPGA versions stored in nonvolatile RAM.
Accesses the menu for upgrading the software image.
Displays installed software versions stored in nonvolatile RAM.
Displays SR1 board hardware information.
Shows the complete configuration, recommended to save.
Configures menu timeout and factory settings.
Accesses and performs bootloader upgrades.
Covers power/lock LED issues and general operation.
Resolves issues with the LAN interface not responding to pings.
Addresses data reception, interface responsiveness, and upgrade failures.
Details specifications for the DVB-S2 receiver mode.
Lists specifications for the receiver's RF capabilities.
Covers LNB power supply and control features.
Details specifications for Transport Stream processing.
Lists specifications for the data interface.
Covers operating conditions, dimensions, and weight.
Details power, management interfaces, and control methods.
Lists configurable parameters like frequency and filters.
Lists parameters that can be monitored.
Outlines maintenance procedures like upgrades.
Lists compliance standards (Safety, EMC).
Details managing and loading FPGA images via TFTP.
Explains management of software components (Bootloader, Application).
Details software image upgrades using TFTP.
Describes software upgrades using Flash Magic.
Covers field upgrades of the BootLoader via TFTP.
Lists changes and fixes for specific software versions.
Documents known issues and workarounds for the SR1.
To Next Page
General