Advanced DVB-S2 Receiver Operational Manual
SR1 Specifications
40
The SR1 can save two FPGA images in its internal non Volatile Memory.
The Show Installed Versions menu includes the following:
Version: The version number of the FPGA image
Image Size: The size of image in Bytes
Valid: Indicates whether the image is
valid and can be used
Active: Select whether to use the image in the next Cold reboot / Power cycle.
7.7.11 Software Upgrade Menu
To view the Software upgrade menu select B from the system.
Software Upgrade
============
1. TFTP Server IP Address 10.0.0.85
2. Filename SR1c1.02build82.asw
3. Show installed versions
4. Start the upload procedure
For further information refer to Chapter 11 SR1 Software and Firmware Upgrade – about
the Software Upgrade procedure.
7.7.11.1 Show Installed Versions Menu
The Show the installed version menu, enables viewing the Software images stored in the SR1
non volatile RAM:
FPGA Versions:
==============
Index Version Image Size Valid Active
1. 6.6b6 245027 Yes No
2. 2.2b20 378857 Yes Yes
The SR1 can save two Software images in its internal non Volatile Memory
The Show Installed Versions menu includes the following:
Version: Version number of the FPGA image
Image size: Size of image in Bytes
Valid: Verify if image is valid and can be used
Active: Select to use the image in the next Cold reboot / Power cycle
Note
For further details about the software Upgrade procedure, refer to Chapter 11 SR1
Software and Firmware Upgrade
To Next Page
Loading...