10. Lamp replacement
Important
• When the operation times of both lamps have e xceeded 4000 hours
3
, you c an operate the pro jector on ly for 3 m inutes after
turning on the powe r. During this time, carry out steps 15 to 20 to reset the lamp operation times.
• The projector does n’t turn on if the lamp cover isn’t attached sec urely.
• Be sure to reset the lamp operation time whenever you replace the lamp.
• Do not reset the lam p operation time unless you replace the lamp.
• The lamp is fragile. If it is br oken, be careful not to cut y ourself with glass fragme nts.
CAUTION: This projector uses a lamp that contains mercury. Disposal of the lamp or the projector with the
lamp may be regulated due to environmental co nsiderations. F or disposal or recycling i nformation, p lease
contact your local authorities or the Electron ic Industries Alliance: www.eiae.org. ( For the U.S. only.)
3. When LAMP MODE is set to STANDARD, this duration will be shorted to 2000 hours.
R5905597 PHXX SERIES 20/05/2014 97