2-3
Installation Verification Operator Manual 920512-768
❑ Electrical supply for unit is as specified on equipment drawing.
❑ Electrical connections between washer and mechanical core are
as specified in S
ECTION 3 of Uncrating/Installation Instructions
(P920512-767).
❑ Verify electrical boxes. Ensure no foreign objects inside electri-
cal boxes. Also check for any unconnected wires.
❑ Verify all electrical connections are plugged in and/or con-
nected.
❑ Building hot water line supplies water to unit as specified on
equipment drawing.
❑ If Drain Discharge Cool Down System with Cold Water Injec-
tion is present, building cold water line supplies water to unit as
specified on equipment drawing.
❑ If Drain Discharge Cool Down System with Chilled Water and
pH Neutralizing System is present, building cold water line
supplies water to unit as specified on equipment drawing.
❑ Building steam line provides steam to unit as specified on equip-
ment drawing.
❑ Building condensate return line is connected to washer as spec-
ified on equipment drawing.
❑ Building waste line is connected to washer as specified on
equipment drawing.
❑ Piping connections between washer and mechanical core are as
specified in S
ECTION 3 of Uncrating/Installation Instructions
(P920512-767).
❑ Building ventilation system is connected to washer as specified
on equipment drawing.
❑ Building air line supplies air to unit as specified on equipment
drawing.
❑ Air line connections between washer and mechanical core are
as specified in S
ECTION 3 of Uncrating/Installation Instructions
(P920512-767).
❑ Verify all clamps and unions on washer and mechanical core.
Tighten if necessary.
❑ All pneumatic connections and switches are properly installed,
adjusted and connected.
❑ If Drying System option is present, drying system connections
between washer and mechanical core are as specified in S
EC-
TION 3 of Uncrating/Installation Instructions (P920512-767).
❑ Springs for emergency stop cables (on top of washer) are cor-
rectly installed on microswitch.
❑ Switch(es) for EMERGENCY STOP pushbutton, located on con-
trol access panel on load side for single door units or on both
load and unload side, if double-door unit, are correctly installed.
To Next Page
Loading...