BG 25 / 2011 / 2254_BG25_en_0000498763_V01
8.2 MEASURES TO TAKE FOR TRANSPORT
MACHINE
Before loading
The machine must be put into the following shape before it may be driven onto a low-
loader or be lifted by a crane:
all attachments have been removed from the mast,
the mast is lowered,
the upper mast section is removed,
the lower mast section is removed (as necessary),
the uppercarriage is in line with the crawlers and locked to the undercarriage,
the crawlers are retracted,
the beam extensions (if so equipped) have been removed.
the counterweights have been removed (as necessary).
After loading
Underpin the lower mast section with transport supports and secure.
Put the safety stick of the pilot control to "OFF" position.
Stop the engine and remove the ignition key.
Lock the cab and remove the key.
Put the battery main switch to "OFF" position.
Tie the machine safely down to the deck of the transporting vehicle.
EQUIPMENT
The rotary drive must be in upright position during the transport.
To Next Page
Loading...
