Baumuller b maXX 1000 - Page 122

Parameter description
Parameter manual b maXX
®
1000
Document no. 5.07004.03 Baumüller Nürnberg GmbH
122
of 208
4.3
P1201
The multi-function input terminals (refer to ZP1091– to ZP1094– are used to select one
of the b maXX
®
1000 multi-step speeds. The speeds (frequencies) are determined by
ZP1210– to ZP1203– as shown above.
P1202
The multi-function input terminals (refer to ZP1091– to ZP1094– are used to select one
of the b maXX
®
1000 multi-step speeds. The speeds (frequencies) are determined by
ZP1210– to ZP1203– as shown above.
P1203
The multi-function input terminals MI3 to MI5 or MI7 to MI12 (refer to ZP1091– to
ZP1093– and ZP1095– to ZP1100–) are used to select one of the b maXX
®
1000 multi-
step speeds. The speeds (frequencies) are determined by ZP1189– to ZP1203–, for fur-
ther information see ZFigure 24– on page 78.
P1204
This parameter displays the ramp function generator input after PID control.
P1201
13. Stufengeschwindigkeit 0.00 to 600.00 Hz
EE 13th step speed frequency 0.00 Hz
ON BM_u_13StepSpeedFrequency 100:1 -
P1202
14. Stufengeschwindigkeit 0.00 to 600.00 Hz
EE 14th step speed frequency 0.00 Hz
ON BM_u_14StepSpeedFrequency 100:1 -
P1203
15. Stufengeschwindigkeit 0.00 to 600.00 Hz
EE 15th step speed frequency 0.00 Hz
ON BM_u_15StepSpeedFrequency 100:1 -
P1204
Anzeige Hochlaufgebereingang nach PID Rege-
lung
0.00 to 600.00 Hz
- Display RFG input after PID control 0.00 Hz
A BM_u_DisplayRFGInputPIDControl 100:1 -