Baumuller b maXX 1000 - Page 67

Parameter
Parameter manual b maXX
®
1000
Document no. 5.07004.03
67
of 208
4
P0908
This parameters determine the increase/decrease of the master frequency when operat-
ed via the multi-function inputs when ZP1091– to ZP1093– are set to 10 (up command)
or 11 (down command).
P0909
The following parameter sets the source frequency for RS485 communication (first or
second frequency).
P0910
The following parameter sets the source frequency for CANopen communication (first or
second frequency).
P0908
Beschleunigung-/Verzögerungsfaktor für Up/Down
Betrieb mit konst. Geschwindigkeit
0.01 to 10.00 Hz/2 ms
EE Accel/decel rate of change of UP/DOWN opera-
tion with constant speed
0.01 Hz / 2 ms
STOP BM_u_AccelDecelRateUpDown 100:1 -
Value Meaning
ZP0807– = 0 Increase/decrease the frequency by using UP/DOWN key. Only enabled, if the b maXX
®
1000 is in state operation.
ZP0807– = 1 Increase/decrease the frequency by acceleration/deceleration setting. Only enabled, if the
b maXX
®
1000 is in state operation.
ZP0807– = 2 Increase/decrease the frequency by ZP0908– (constant speed).
ZP0807– = 3 Increase/decrease the frequency by ZP0908– (pulse input).
P0909
Quellfrequenz der RS485 (Modbus) Kommunikati-
onsschnittstelle (U/min)
-32768 to 32767 rpm
- Source frequency for RS485 (Modbus) commu-
nication interface (rpm)
0 rpm
ON BM_u_SourceFrequencyRS485 1:1 -
P0910
Quellfrequenz der CANopen Kommunikations-
schnittstelle (U/min)
0 to 36000 rpm
- Source frequency for CANopen communication
interface (rpm)
0 rpm
A BM_u_SourceFrequencyCANopen 1:1 -