To Next Page

To Previous Page

Page52

AllSensors

OutletGroups

ListOutletGroups

AddGroup

For configuration of all sensors of selected type in system with a

single user-supplied value.

1...Contact

2...Temperature

3...Humidity

4...Air Flow

Enter Request :1

RPC/RPS External Environmental Sensor Configuration Menu

Sensor Number: All Name: all RPCs/RPSs

Type: Temperature/Humidity/Air Flow

1...High Threshold (tenths of meas. unit): NP

2...High Threshold Trap Enable: NP

3...Low Threshold (tenths of meas. unit): NP

4...Low Threshold Trap Enable: NP

Enter Request :

Enter threshold value in tenths of unit measurement (degrees,%%,etc.):

Select 2), to set parameters for the

different probe types. This feature is

useful for standardization and the

probe type is known.

Environmental Sensor Configuration Menu

Sel M/P Identifier

1 2/1 MMP10

2 All Sensors

Enter Request :2

Option 1 and 3 sets the temperature

levels to the tenth of a degree. Option

2 and 4 enable the SNMP traps to be

sent if the corresponding threshold

had been exceeded.

NOTE: NP = No Probe detected.

NOTE: The type ‘Contact’

signifies the unit does not

recognize or detect a probe, but

still be able to send SNMP Traps.

Group Name Outlets

1 Router GP-A 2.1.1,2.1.2,2.1.3,2.1.4

2 Server Row 2.1.5,2.1.6,2.1.7,2.1.8

3 Radius 2.1.9,2.1.10,2.1.11,2.1.12

4 Server backup 2.1.13,2.1.14,2.1.15,2.1.16

List up to four outlets in the following form

mod.port.outlet,mod.port.outlet

2.1.1,2.1.2,2.1.3,2.1.4

utlet Group Configuration:

List Outlet Groups...............1

Add Group........................2

Delete Group.....................3

Rename Group.....................4

Modify Outlets in a Group........5

Delete All Outlet Groups.........6

Enter Request :1

Select 6), from the RPC Management

Menu, allows user to combine outlets

from different modules and ports. One

SNMP command is used to turn off/on or

reboot the group

Select 1), to list any outlet groups:

Select 2), to add a new outlet group:

Each outlet is represented by

Mod.Port.Outlet. i.e. Mod 2 dot port

dot outlet number 1 =2.1.1

NOTE: Mod 2.Port 1.Outlet.# is for the MASTER unit and Mod 2 .Port 2. Outlet # is for

the Slave unit

Brand	BayTech
Model	MMP
Category	Switch
Language	English

BayTech MMP User Manual

Table of Contents

Questions and Answers:

BayTech MMP Specifications

Related product manuals