AR6201 - RT6201 - RCU6201 - AR6203
DV 14307.03 Issue 1 7/2013 Page 3-9
Note: If the device is operating in the 25 kHz mode a selection of an
earlier stored 8.33 kHz channel is not possible. For selection of
8.33 kHz channels, the device has to be operated in 8.33 + 25 kHz
mixed mode.
3.5.4 Scan Mode
In all frequency selection modes;
1. A long press of “↕/SCN” key activates the scan function and changes to
STANDARD MODE if activated from CHANNEL or DIRECT TUNE mode.
2. A short push on the “MDE” key or a long press on “SCN” key terminates
scan function. After leaving scan function, the device will remain in
standard mode (chapter 3.5.1).
In scan mode the display shows both the active frequency on the top line and
the preset frequency on the bottom line. The SCAN sign in the display
indicates that scan function is active.
If both the active frequency and preset frequency simultaneously detect a
signal, the active frequency takes priority. The preset frequency then
inverts and blinks. The arrow sign “►” in front of the active frequency
indicates that this frequency is audible. The figure below shows a sample.
If selected in the installation setup an audio notification “beep” tone
becomes audible in addition to the blinking preset frequency to indicate the
presence of an RX signal on the preset frequency.
Reception on Preset Frequency in Scan Mode
If the preset frequency detects a signal while no signal is present on the
active frequency, the transceiver automatically switches over to the preset
frequency.
To Next Page
Loading...
Need help?
General
