AR6201 - RT6201 - RCU6201 - AR6203
DV 14307.03 Issue 1 09/2013 Page 2-1
Section 2 INSTALLATION
The installation of the VHF transceiver depends on the type of aircraft and its
equipment. Therefore, only general information can be given in this section.
2.1 Limitations
The installation of the AR620X is designed for use in cockpit environment of
general aviation aircrafts including helicopters. For installation the
following limitations apply:
• Installations have to be in accordance with appropriate EASA or FAA
approved guidelines. The personnel installing this article must ensure
that the aircraft installation conditions are within the ETSO/TSO
standards applicable for the specific type or class of aircraft,
• The 620X VHF Transceiver must be connected to a VHF antenna in order to
satisfy FAA TSO-C169a.
• The conditions and tests for ETSO/TSO approval of this article are minimum
performance standards.
• The equipment is not intended for installation in areas where fluid
contamination could be commonly encountered.
Note: Changes or modifications made to this equipment not expressly approved
in written form by BECKER may void the authorization to operate this
equipment.
2.2 Unpacking the Equipment and Preparation for Installation
General
Visually inspect the package contents for signs of transport damage.
Carefully unpack the equipment and check for completeness. Retain all
packaging material in case reshipment becomes necessary.
Additional Required Equipment
The 620X VHF Transceiver is intended for use with standard aviation
accessories. The following equipment is required for installation:
• VHF COM Antenna with coaxial 50 Ω impedance cable and BNC connector
• Microphone and headphone or speaker
2.3 Mechanical Installation
2.3.1 AR6201 and RCU6201 Installation
The AR6201 and RCU6201 are designed to be mounted in the aircraft instrument
panel within easy view and reach of pilot/operator. The mounting location for
AR6201 shall be at least 30 cm away from the aircraft magnetic compass, to
avoid any interference to the magnetic compass by the transceiver. The
mounting location for RCU6201 has no restrictions. For unit dimensions refer
To Next Page
Loading...
Need help?
General
